iFixit - Answers With Device "Mazda"

1998-2002 Mazda 626: hold ışığı yanıp sönüyor

Sat, 13 Apr 2024 13:57:49 -0700

1998 model Mazda 626 aracım

otomatik şanzıman 1 2 3 viteslerde sorun yok 4.vitese geçeceği sırada HOLD ışığı yanıp sönüyor vites 4 geçmiyor tamirciler elektrik arızası var diyor obd cihazında arıza çıkmıyor fakat arızayı bulamıyoruz (arabayı her kapatıp açtığımda aynı oluyor 1.2.3 sorun yok ama 4 geçmiyor)

2004-2009 Mazda 3: 2008 model 1.6 dizel güc kaybı var turboda sorun yok

Fri, 12 Apr 2024 02:53:44 -0700

ben fransada yaşıtorum burada bir ustaya götürdüm aracın bilgisayar bağladı hergi bir hata olmadığını söyledi turbo değişti fap temizlendi ama araçtaki güç kaybı düzelmedi

⟐ Answered Nisan 12, 2024 at 2:53 GMT-7

1998-2002 Mazda 626: Çözülmeyen Rölanti sorunum var

Fri, 16 Feb 2024 06:32:21 -0700

Bir türlü çözemediğim rölanti problemi var. Ateşleme ile ilgili herşeyi değiştirdim. Rölanti motorunu değiştirdim.

⟐ Answered Şubat 16, 2024 at 6:32 GMT-7

2009-2013 Mazda 3: rwm arızası nasıl tamir olur

Fri, 12 Apr 2024 13:45:28 -0700

Rwm ışığı sarı yanıyor

1989-1994 Mazda Protege: Why is my cooling fan not kicking on?

Sat, 09 Jul 2022 19:23:57 -0700

cant find cooling fan relay

⟐ Answered Temmuz 09, 2022 at 19:23 GMT-7

2004-2009 Mazda 3: Mazda 3 Check Engine Light P0126 & P0128

Fri, 19 Apr 2024 18:46:10 -0700

The two codes from the check engine light are: P0126 & P0128

Here is what I found according to my research:

P0126 is either replace coolant temperature sensor or replace the thermostat. According to my research, 99% of the people who had this code needed to replace the thermostat. Once that was replaced, 99% of the people said that the light turned off and that they noticed the car ran better than it did before. Some people said that the repair is about $100 (including the parts and labor) and that no one should pay over $200. People said that they were even able to replace it themselves (if you can get under the car). The thermostat part is LF7015170. I looked it up online from a Mazda parts dealer and it's about $45-$50 depending on which parts dealer you buy it from. I'm sure I could even find it on eBay for cheap too.

P0128 indicates that the computer is detecting that the engine is not reaching operating temperature within a reasonable time after startup. I am guessing that this relates to the issue with the thermostat, but I'm not 100% sure.

CAN ANYONE GIVE ME MORE ADVICE/INFORMATION AS TO WHAT I SHOULD DO? HOW MUCH IT WILL COST?

⟐ Commented Nisan 19, 2024 at 18:46 GMT-7

2002–2008 Mazda 6: Why wont it shift pass 3 gear

Sun, 15 Feb 2026 09:47:03 -0700

I have a 07 Mazda 6 and it wont shift pass 3 gear does anyone know what my problem is it has a 1.8 and a automatic transmission and my at light is on and when i switch it over to Manuel it does nothing its like it not even there

⟐ Commented Şubat 15, 2026 at 9:47 GMT-7

1998-2002 Mazda 626: Which relay on fuse block is for the fuel pump?

Sun, 15 Jan 2023 12:00:23 -0700

Not getting fuel to motor. Don't hear fuel pump when turn key on. Fuse is good on fuse block. Thought there might be a relay. Also looking for a repair manual in anticipation of replacing the fuel pump. Any help with testing circuit greatly appreciated.Is there a way to put power directly to fuel pump?

⟐ Commented Ocak 15, 2023 at 12:00 GMT-7

2000-2007 Mazda Tribute: Where is temperature sensor located?

Thu, 14 Aug 2025 07:58:38 -0700

Where can I find the temperature sensor on my 2003 Mazda Tribute 4 cylinder engine

⟐ Commented Ağustos 14, 2025 at 7:58 GMT-7

1998-2003 Mazda Protege: Heater only blowing out front vents, no heat to feet or defrost. Why?

Thu, 01 Feb 2024 12:17:23 -0700

Heater working but only blows out front vents. No heat to feet or defrost. Before replacing Heater Control Unit, it would only blow hot air from front vents- With this replacement it will now change from cold to hot and the air flow pressure does change from the front vents when changing the setting dial but there is still no air at all to feet and defrost. Can anyone tell me if there is a louver or valve that could be jammed and where to locate it? Or what else to try? Thanks!

Desperately Seeking Defrost :)

⟐ Commented Şubat 01, 2024 at 12:17 GMT-7

2004-2009 Mazda 3: Intermittent check engine light caused by error P0128

Sat, 14 Jan 2023 09:35:25 -0700

My 2004 Mazda 3's check engine light is coming on periodically. I hooked up a tester to it and it's error P0128. What does that mean?

⟐ Commented Ocak 14, 2023 at 9:35 GMT-7

2004-2008 Mazda RX-8: 2006 RX-8 will not start.

Sat, 10 Aug 2024 19:09:45 -0700

2006 RX-8 will not start. Getting it to turnover but not firing. Replaced battery, plugs and starter and still not firing up. I am at a loss right now as to what to do. A mechanic told me to squirt oil into the spark plug wells and with the plugs out try to fire it up. Any help would be so greatly appreciated!

⟐ Commented Ağustos 10, 2024 at 19:09 GMT-7

1989-1994 Mazda Protege: How to replace waterpump?

Tue, 09 Feb 2021 14:38:18 -0700

How do you replace the waterpump on a 1994 Mazda Protege ?

⟐ Answered Şubat 09, 2021 at 14:38 GMT-7

1998-2003 Mazda Protege: I think my car is losing power to 1 cylinder.

Wed, 19 May 2021 02:22:21 -0700

'99 Mazda 323 Protege.

Manual, fuel-injected, 4cyl.

Engine code: CE04D16

ok so just recently started having troubles with the car. It ran fine then all of a sudden I lost what felt like 15-25% power, and the engine felt like it was shaking a little.

When revving, then engine would shudder. Idle rev went from just over 1000 to around 500. there was very little pickup when increasing speed. I can only assume it lost a cylinder. Now for the last couple days it has been jumping backwards and forwards, from regular to slow.

What is the problem, can I fix this myself, or do I need to take it to a mechanic?

⟐ Commented Mayıs 19, 2021 at 2:22 GMT-7

Mazda: Fix the driver's side door interior panel in Mazda Tribute SUV?

Tue, 30 May 2017 07:06:07 -0700

The interior driver side door latch no longer works. I suspect the linkage inside the door has broken or come apart. I need to know how to disassemble the door panel to gain access to the door latch mechanism.

⟐ Answer accepted Mayıs 30, 2017 at 7:06 GMT-7

2004-2009 Mazda 3: help ...tcmwiring plug 06 mazda3 2.3 tcml32e tcm K

Tue, 11 Nov 2025 01:18:49 -0700

please help i need the diagram for 06 mazda 3 2.3L TCM control plug wiring plug B1_1 redo on harness side of TCM female connector lost track of wiring location on plug for tcm pins 06 mazda 3 tcm k # l32e189e1b other# k6266 plug B1-1 possistion of were each color goes in pinout

⟐ Commented Kasım 11, 2025 at 1:18 GMT-7

2002–2008 Mazda 6: How do you change the upstream o2 sensor

Fri, 28 Dec 2018 07:36:54 -0700

the check engine light is on and a mechanic put a machine on it an it detected the upstream o2 sensor

⟐ Commented Aralık 28, 2018 at 7:36 GMT-7

1998-2003 Mazda Protege: Bad idle, Rpm unstable

Thu, 04 May 2023 15:12:40 -0700

What cause this problem ? Idle move from 600 rpm to 1100 and drop to 400 and back to 1000 non stop. ?

All explain are approximative value.

The model is Mazda protege 2002, 2.0 Lit

The ODB read a alarm code miss fire.

Some people think that could be a timing belt problem

The mileage is around 109 k km

Thank you in advance

Yvon K

⟐ Answered Mayıs 04, 2023 at 15:12 GMT-7

2004-2009 Mazda 3: Repair of sunroof so it will close/open

Wed, 14 Jan 2026 11:36:22 -0700

My sunroof is stuck in the 85% close position. Pushing either the open/close switch you just hear a 'rattat-tat' sound and the sunroof remains in the same position for most of the time. Some times it does move half an inch either way but that's all. I need to get under the headliner and be able to see if there are any small bolts loose/missing and what the track assembly looks like. Can you help and by chance also provide me with an excerpt from the factory service manual?

Sure. I thought I included it. It's a 2006 Mazda 3 and is a 4dr. Can you also find info for removing a portion of the overhead headliner in order to be able to work on the sunroof motor and track assembly?

Thank you.

⟐ Commented Ocak 14, 2026 at 11:36 GMT-7

Aircon: Car shut off while coming to a stop.

Sun, 26 Apr 2026 20:35:49 -0700

Everything was put in new. 02 sensors, mas air flow sensor. Everything. But code stated 02sensor bank 1. Plz help thank you.

⟐ Answered Nisan 26, 2026 at 20:35 GMT-7