Ana içeriğe geç
Yardım

Güncel sürümün sahibi: Minho ,

Metin:

It looks like a decent quality soldering station (I haven't used one though, just going on appearances). However, you will not be able to do a lot of micro-soldering with this setup as the tips are just too big. It will be fine for "soldering" through hole components.
 
Fo "micro-soldering", you need smaller tips or preferably micro-tweezers so that you can heat both sides of the smaller SMD components. AnotherYou could look at the [http://quick-global.com/1-common-soldering-1.html|QUICK236ESD] which has a nice range of tips.

Another
option to consider is a hot air station. That will also allow you to do SMD passives as well as micro-BGA. The [http://quick-global.com/2-lead-free-rework-2.html|Quick 861DW] station is well rated.

Of course, you could get the higher-end and higher cost professional stations like Hakko, JBC, PACE etc but the Quick products tend to be well rated and not too costly.
Fo "micro-soldering", you need smaller tips or preferably micro-tweezers so that you can heat both sides of the smaller SMD components. AnotherYou could look at the [http://quick-global.com/1-common-soldering-1.html|QUICK236ESD] which has a nice range of tips.

Another
option to consider is a hot air station. That will also allow you to do SMD passives as well as micro-BGA. The [http://quick-global.com/2-lead-free-rework-2.html|Quick 861DW] station is well rated.

Of course, you could get the higher-end and higher cost professional stations like Hakko, JBC, PACE etc but the Quick products tend to be well rated and not too costly.

Durum:

open

Orijinal gönderinin sahibi: Minho ,

Metin:

It looks like a decent quality soldering station (I haven't used one though, just going on appearances). However, you will not be able to do a lot of micro-soldering with this setup as the tips are just too big. It will be fine for "soldering" through hole components.

Fo "micro-soldering",  you need smaller tips or preferably micro-tweezers so that you can heat both sides of the smaller SMD components. Another option to consider is a hot air station. That will also allow you to do SMD passives as well as micro-BGA. The [http://quick-global.com/2-lead-free-rework-2.html|Quick 861DW] station is well rated.

Durum:

open