Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

Yardım

Güncel sürümün sahibi: Sam Goldheart ,

Başlık:

Which conductive ink would you recommend?
Which conductive ink would you recommend?

Metin:

I know this is a bit off topic, however it is repair related. I have an iBook that I am trying to repair. The power connector ripped off the conductive pads, the trace snaps if you go near it with solder! I tried a conductive glue but am not happy with the results, it is waterbased and difficult to control where it's going. I put it on the board but have since removed it because I don't think it will work blah blah blah.

So..[http://www.ebay.co.uk/itm/370515087749?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649|this] is what I originally was looking for, a silver conductive pen so I can "write" the connections with accuracy. Anyone know whether it's good, recommend anything else?

Cihaz:

conductive inkElectronics
conductive inkElectronics

Durum:

open

Kabul Edilen Cevap:

68256

Düzenleyen: pollytintop ,

Başlık:

Which would you recommend?

Metin:

I know this is a bit off topic, however it is repair related. I have an iBook that I am trying to repair. The power connector ripped off the conductive pads, the trace snaps if you go near it with solder! I tried a conductive glue but am not happy with the results, it is waterbased and difficult to control where it's going. I put it on the board but have since removed it because I don't think it will work blah blah blah.

So..[http://www.ebay.co.uk/itm/370515087749?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649|this] is what I originally was looking for, a silver conductive pen so I can "write" the connections with accuracy. Anyone know whether it's good, recommend anything else?

Cihaz:

conductive ink

Durum:

open

Kabul Edilen Cevap:

68256

Orijinal gönderinin sahibi: pollytintop ,

Başlık:

Which would you recommend?

Metin:

I know this is a bit off topic, however it is repair related. I have an iBook that I am trying to repair. The power connector ripped off the conductive pads, the trace snaps if you go near it with solder! I tried a conductive glue but am not happy with the results, it is waterbased and difficult to control where it's going. I put it on the board but have since removed it because I don't think it will work blah blah blah.

So..[http://www.ebay.co.uk/itm/370515087749?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649|this] is what I originally was looking for, a silver conductive pen so I can "write" the connections with accuracy. Anyone know whether it's good, recommend anything else?

Cihaz:

conductive ink

Durum:

open