Ana içeriğe geç
Yardım

Orijinal gönderinin sahibi: Andrew Lavigne

Başlık:

How to separate air 2s lens module from CCD board?

Metin:

I've got an air 2s camera whose autofocus motor is not functioning properly. Everything else about the camera (and of the gimbal) works fine - calibration is good, everything. Just that the autofocus motor click-click-clicks upon startup and it is most of the time is unable to focus on anything.[br]
[br]
I have sourced a new lens component (the thing with the optics and the autofocus motor and related electronics). The thing is, I cannot figure out how to separate the CCD board (which contains the sensor) from the old/bad lens component. I've tried prying in different ways but I really don't want to break the CCD board. I was wondering if anyone on the forum knows how these two parts are attached and how I can separate them. It may be that we're just talking about some glue that I need to heat up to separate, but I'd like to consult with those in the know before giving it a go.

Can anyone who has experience describe how the CCD board on the back of the camera module attaches and can be separated from the lens and lens housing?

Cihaz:

DJI Mavic Air 2

Durum:

open