Ana içeriğe geç
Yardım

Güncel sürümün sahibi: oldturkey03 ,

Metin:

Adin, here is my answer from a similar question "the normal procedure is to hold down the "end of cycle signal" (drain/spin)button for 3 to 5 seconds. The only other thing I could see is that the control interface has failed and has a stuck or shortened keypad. Or you can try to reset it by unplugging your machine, and plug it back in after 5-10 min. There is also the possibility that the interface ribbon cable became dislodged. Let us know what, if anything, work. Hope this helps, good luck.
Adin, here is my answer from a similar question "the normal procedure is to hold down the "end of cycle signal" (drain/spin)button for 3 to 5 seconds. The only other thing I could see is that the control interface has failed and has a stuck or shortened keypad. Or you can try to reset it by unplugging your machine, and plug it back in after 5-10 min. There is also the possibility that the interface ribbon cable became dislodged. Let us know what, if anything, work. Hope this helps, good luck.

Durum:

open

Orijinal gönderinin sahibi: oldturkey03 ,

Metin:

Adin, here is my answer from a similar question "the normal procedure is to hold down the "end of cycle signal" (drain/spin)button for 3 to 5 seconds. The only other thing I could see is that the control interface has failed and has a stuck or shortened keypad.  Or you can try to reset it by unplugging your machine, and plug it back in after 5-10 min. Hope this helps, good luck.

Durum:

open