Stripped solder pad on battery connector

Hello,

I was attempting to de-solder the battery from an ipod touch 4th gen., sadly I stripped the solder pad for the thermistor pin. Power and ground pins are fine. I am wondering if the ipod will work without the temperature sensor pin connected, and if not, how can I repair the trace, I was thinking silver conductive glue. Any advice or suggestions appreciated

thank you for your time

Yanıtlandı! View the answer Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Puan 0
Yorum Ekle
Spread Fixmas Cheer
Get $12 off your purchase of $50 or more with code FIXMAS12
Spread Fixmas Cheer
Get $12 off your purchase of $50 or more with code FIXMAS12

1 Cevap

Filtre ölçütü:
Seçilen Çözüm

matt prior, you are not the first person that this happens to. Here is my answer from a very similar question:" If the pad has been completely ripped off the board, the only options would be:

1) Find the trace the pad normally connects to, scrape off some lacquer and re-attach to a new point. or 2) Replace the whole board. You should be okay with attaching the cable to the race or the next point where the trace leads to. You need a good magnifying lamp, a steady hand and good equipment. You should also check on here Anyway to reattach solder pads? " This is from solder pads on iPod Touch 3g battery replacement. Check this link for all the questions/answers about solder pad repair. No, it will not work properly unless it is all connected the way it is supposed to. Hope this helps, good luck.

Bu yanıt yardımcı oldu mu?

Puan 1
Yorum Ekle

Yanıtını ekle

matt prior sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 6

Her zaman: 3,860