Eşyalarını Tamir Et Topluluk Mağaza

2.2, 2.4, 2.5, or 2.6 GHz Core 2 Duo processor

759 Soru Tümünü görüntüle
Soru Kapandı

Seçenekler

After Replacing HD the Fan is Always on

I replaced the original 120 gb 5400 rpm drive which was making a lot of noise in my A1226 with a 320 Gig Seagate 7200 RPM drive. Since that time the fan runs constantly from Boot. Before this, It would run depending on how hard the CPU was running, but now if everything is Idle the fan will still runs.

The only thing I can think of is I did not do a clean install on the new Drive I just copied off a Super duper archive, but I may be wrong about that.

Any thoughts?

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 0
Yorum Ekle

1 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski

Seçenekler

Did you connect the heat sensor back on logic board?

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 0

2 Yorum:

I didn't remember taking it off. I did just check the Hard drive replacement instructions and the Heat Sink Replacement instructions and the Sensor Cable is nowhere near where I was working, unless thre is another cable I don't know about.

tarafından

Try this

http://support.apple.com/kb/HT3964?viewl...

or this

http://support.apple.com/kb/HT1379

At last try AHT (apple hardware test) and tell us what errors is giving.

If nothing instal smc fan control and adjust minimal rpm manualy

tarafından

Yorum Ekle
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 2,522