I had this and it was damaged to due to water spill- I got it cleaned up and it appears to be working fine however, it won't charge. I used another magboard and the green light is all I get. I also replaced the battery - I'm at a loss- any ideas on how to get this charging?
Bu iyi bir soru mu?
İtibar: 116,3b
66
68
359
Depending where the liquid entered the machine it could be the the battery connector. Check that your connections are correct to the logic board. If they are look for damage/corrosion with a magnifying glass. Damaged component repair is an advanced DIY project you may have to seek professional help. (A simpler DIY fix would be a logic board replacement - compare the cost/value of each).
If this Answer is helpful please remember to return and mark it Accepted.
Bu yanıt yardımcı oldu mu?
Son 24 Saat: 0
Son 7 gün: 0
Son 30 gün: 0
Her zaman: 189
