Eşyalarını Tamir Et Topluluk Mağaza

Apple iPhone 5s, 10 Eylül 2013 tarihinde duyuruldu. Bu cihazın tamiri, daha önceki modellerinkiyle benzerdir; tornavida ve plastik açma araçları gerekir. GSM ya da CDMA olarak, 16, 32, 64 GB kapasiteli Gümüş, Altın ve Uzay Grisi renklerinde mevcuttur.

3531 Soru Tümünü görüntüle

Seçenekler

Battery adhesive removal failure

I have tried to use ifixit guide to replace battery in my iPhone 5s.

When I got to steps to remove adhesive tape, unfortunately the tape tabs just went off (just tore off) without removing adhesive from underneath the battery.

These are steps 21-25 here: How to replace the battery in your iPhone 5s

How can I still remove the old battery?

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 14
Yorum Ekle

4 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
En Yararlı Yanıt

Seçenekler

Heat up the rear of the iPhone were the battery is situated the aluminum part..

Now pry the battery up with a metal pry tool only pry on the volume keys side not on the motherboard side..

Pry in the middle and bottom side of battery as there is flex cables under the battery at the top of it.. The battery will bend as the adesive is really tuff but saying as your changing the Battery this doesn't matter

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 5

1 Yorum:

Ir worked! Thank you.

tarafından

Yorum Ekle

Seçenekler

when the adhesive strips are broken , you can try using fishing line to remove the adhesive from under the battery - https://www.youtube.com/watch?v=gkCyl7kR...

also this method using steel wire seems even better - https://www.youtube.com/watch?v=W5GzU11q...

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 2
Yorum Ekle

Seçenekler

Don't heat up adhesive tabs used to hold down batteries of iPhone 5s, 6 Etc. These are command strips from 3m and become brittle when heated. If you break them off gently pry up on battery using plastic pry tool or isesamo. Be extremely careful not to puncture battery. I get the battery up enough to use curved tweezers and grab a hold of that command strip and pull directly away from itself.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 0
Yorum Ekle

Seçenekler

I did two battery replacements back to back, and on the second I used the black spudger as a spool, basically: # NOT cutting the tabs in 2

  1. laying the spudger across the frame with the edge over the battery's bottom edge and pulling the tabs over it
  2. Slowly rolling the spudger towards the home button, keeping the angle of tape more or less vertical from the battery's edge.

On side of the tape broke early on because i misunderstood ifixit's directions and was pulling the tape forward at an angle over the home button hardware. I can't say for certain this method would work consistently but I was surprised how well it did- certainly better than pulling and re-gripping separate tabs.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 0
Yorum Ekle

Yanıtını ekle

andrewborodenko sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 9

Son 7 gün: 37

Son 30 gün: 140

Her zaman: 37,700