Ana içeriğe geç

The Canon AE-1 is a 35 mm single-lens reflex (SLR) film camera for use with interchangeable lenses.

31 Soru Tümünü görüntüle
Soru Kapandı

Broken the Rewind Button/Stick and corresponding piece inside

I have managed to break the Film Rewind 'stick' when trying to wind the film back when I finished a roll (I think it may have been cracked already from prior use).

Has anyone got any idea how to fix/replace it? I was planning on having a go at it tonight (seeing the small flathead screw there), but thought it best to seek advice first.

Will the camera still operate ok without it if I can't fix/replace it?

Any advice would be greatly appreciated, thanks.

Please forgive the poor iPhone photo: Broken piece

Yanıtlandı! Cevabı görüntüle Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Puan 0
Yorum Ekle

1 Cevap

Filtre ölçütü:
Seçilen Çözüm

Ouch!

That is the sprocket drive which advances the film. What may have happened the sprocket drive release button didn't get pushed when you tried to rewind the film or for some reason failed to disengage.

OK the bad news! This is a big job as you'll need to take almost the entire camera apart to get to the part and there are some fragile electronics wrapping around all of this as well.

Unless you have the skills to work on the delicate insides of a watch or camera I wouldn't tempt fate here. Best to get your camera to a Canon authorized service center for the repair. Sorry ;-{

Bu yanıt yardımcı oldu mu?

Puan 1

2 Yorum:

Thanks very much for the response Dan - as the camera has sentimental value I reckon I'll take it to an authorised repair shop and just bite the bullet. Darn!

tarafından

Sorry for the bad news, It happened to me on my Olympus OM-1 camera years ago. Which by the way I still use! If this answer answered your question please remember to rate (score) and mark it accepted.

tarafından

Yorum Ekle
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 1,886