Eşyalarını Tamir Et Topluluk Mağaza

Model A1225 / Early 2009 / 2.66, 2.93, or 3.06 GHz Core 2 Duo processor

164 Soru Tümünü görüntüle

Seçenekler

The mac hangs on blue screen and doesn't starts the systemsoftware

At startup the mac doesn't go true with its startup sequence and hangs on the blue screen.

The machine is still acessable as a external harddrive (at startup hold the letter T) but is slow and cant copy much at the same time.

- Multiple times cleaned PRAM didn't help

- HDD check was OK

- Hardware check didn't complete (hanged on the check)

- Did a clean instal of OSX 10.5 (original disc) no luck their either

What i didn't check yet is the RAM.

What can be the problem

Yanıtlandı! Cevabı görüntüle Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan -1
2 Yorum

How did you check the hard drive? From the system installation disk or in target mode and with what?

tarafından

See comment below.

tarafından

Yorum Ekle

3 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
Seçilen Çözüm

Seçenekler

At this point, if it starts in target mode, I would reformat the drive and use the "write zeros" option to map out any bad blocks the drive has and reinstall the system. That failing, I would replace the drive.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 1

2 Yorum:

I formatted the drive and did a clean install. But did not perform a 'write zeros option', YET. Isn't their any change that it could be the RAM?

tarafından

You can check the RAM if you want to by removing one stick and booting then switch the RAM stick and boot, then do the same in the other slot. But I really see no indication of a RAM problem.

tarafından

Yorum Ekle

Seçenekler

I checked the hard drive from the system installation disk but diskaid did not find the drive at that point. So i checked the drive with Disk Warrior 4.2 and the drive came out fine. I can also see the drive if I do a computer to computer link with option letter T at startup. And that works fine to.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 0

1 Yorum:

If the system installation disk does not see the drive, somethings wrong with the system disk or the hard drive. Try it in Target mode - with the firewire and see if you can run disk utilities from t he other computer. Repair the drive and also the permissions.

tarafından

Yorum Ekle

Seçenekler

Thanks for the comments so far. I am going to check everything mentioned.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 0
Yorum Ekle

Yanıtını ekle

u2peer sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 2,678