Ana içeriğe geç

The Samsung NaviBot SR8855 is a handy autonomous vacuum by Samsung.

20 Soru Tümünü görüntüle

Short shift and turn.

Navibot sr8855 after repair of FET tranzistors for brush have bad mooving - navigation.

From the beginning it worked well and after some time was problem in navigation.

It looks like that: move 20-30cm stop and go back about 3cm, turn 90st. and repeat.

Sometimes work good for 1 minute and then again fail to this state.

I try test mod and all sensors look fine, motors are OK too.

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Puan 1

1 Yorum:

I have the same issue. Is there a fix?

tarafından

Yorum Ekle

5 Cevap

Filtre ölçütü:

Hi,

yes, i found that it was dusturbation in system . I add some capacitors on motor and all is OK

Bu yanıt yardımcı oldu mu?

Puan 0
Yorum Ekle

Can you describe more precise what did you done?

Could be the aging of the accumulator?

Bu yanıt yardımcı oldu mu?

Puan 0
Yorum Ekle

I must replace suction motor and with it start the disturbance of electronics. For this I used capacitors on motor pads. I was 1nF + 100nF + 1uF together. To other motors must be carefull becouse are PWM drivered. There You can use only some smaller - max 100nF capacitors.

Bu yanıt yardımcı oldu mu?

Puan 0

1 Yorum:

Hi

What voltage do you use in capacitors?

tarafından

Yorum Ekle

Can be that the battery started to decay?

Bu yanıt yardımcı oldu mu?

Puan 0
Yorum Ekle

It could probably have an effect but it is not a reason.

Bu yanıt yardımcı oldu mu?

Puan 0
Yorum Ekle

Yanıtını ekle

smsoftware sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 gün: 1

Son 30 gün: 1

Her zaman: 1,927