MBA11 E 2014 Water damage. No response after cleanup. Or xmas miracle

Hi everyone,

I know it's repeated issue and I know because I have read every single article about it, but still no answer, so, hope you can help me out here.

The facts:

-Spilled maybe 50ml of beer (like the neck of a long neck) over my MBA 11 inch Early 2014.

-unpluged it and turned it off, fliped over and dry the outside, bang my head for being stupid.

-Aparently I was drunk and thought it wasn't too much so, after a few minutes of cleaning I turned it back on. It was ok, until it was not and it shut itself off, just like my brain before that. Anyway, I started reading every sinlge thread on water damage ever written.

-Next morning I checked on it and It turned on but it wasn't charching (no green/orange light). So, I closed everything and went to buy a shiny pentalobe 1.2 and a T5. Once it was open, I cleaned every bit I could see, but not underneath the transistors and $@$* but got rid of all the beer and corrotion. Waited until dry and try again. It was charging and it was working. Well done pal, I said to myself, you earned a beer, away from you MBA this time.

I started doing some back up and it just died.

So then I opened it again but with a new gang, distilled water, brush and isopropyl alcohol and bathed the bits down, dry and putted everything back where it belonged but it didn't came back. There's a green light on the magsafe, but it won't turn on.

Sorry for the long post but I feel this as a full support group, not just tech. ha.

Well, my question now is, what should I replace now?

the I/O Board is working and the battery seams to be fine, physically as it wasn't reached by the beer (maybe it's damaged too, how do I check?). So I'm guessing the worst. Logic board.

What do you guys/gals think, what would you do?

Thanks every one and iFixit for giving back to the people their right to fix their own $@$*. Amen.