Ana içeriğe geç

HP ProBook 4320t manufactured in May of 2010.

3 Soru Tümünü görüntüle

Can't remove CPU heatsink because two of the screw heads are damaged

I replaced the thermal paste on the CPU and Radeon chip in a 4320s a couple years ago due to over heating causing shutdown on boot which fixed the issue.

It's happening again but this time I can't remove the heat sink because two of the screws holding it in place are damaged and won't turn no matter what screwdriver I try. The driver just spins in the head of the screw.

Any advice would be greatly appreciated.

Thanks in advance!

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Puan -1
Yorum Ekle

1 Cevap

Filtre ölçütü:

Have you tried these:http://www.amazon.com/Alden-8440P-Grabit...

Or use a round disc bit to carefully grind a line in the screw with a dremel so the screwdriver will grip?

Bu yanıt yardımcı oldu mu?

Puan 0
Yorum Ekle

Yanıtını ekle

Zayn sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 522