İtibar: 1,6b
12
5
3
Customer brought in an iPad Pro 12.9" with a cracked screen. I replace the screen and soldered the new one on properly 100%. Customer has issues with the dead spot on the screen. So I ordered a brand-new digitizer assembly and install that one. Exact same issue as the first one. Anybody have any suggestions? No apparent damage to the control board and soldering is good. Thanks!
Bu iyi bir soru mu?
İtibar: 1
1
then the controller board is bad, simple
sounds to me like proccess of elimination its the controller board, too much heat, etc can damage a controller board, hope you find a solution.
Bu yanıt yardımcı oldu mu?
İtibar: 61
3
lcd is not ok failure
Bu yanıt yardımcı oldu mu?
LCD is perfectly fine on both. Ordered from 2 separate manufacturers, dead spot in same exact area.
Son 24 Saat: 0
Son 7 gün: 1
Son 30 gün: 2
Her zaman: 475
Same supplier? Seconds?
mayer tarafından
Different Supplier. LCD is good on both.
GadgetERService tarafından