Ana içeriğe geç

Can switching regulators cause interference on wifi based circuits?

I read that buck and boost converter due its switching mode produces too many noises compared with linear regulators but it is more efficient.

Can those those noises cause interference on boards with wifi chips on it?

How would be a good way to measure how big would be such interference at the point to determine that it is worth to use a linear regulator even without power efficiency?

Yanıtlandı! Cevabı görüntüle Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Puan 0
1 Yorum

Hi, This might be a good starting point.

http://www.ti.com/lit/an/slva219a/slva21...

tarafından

Yorum Ekle

1 Cevap

Filtre ölçütü:
Seçilen Çözüm

I am not an electronics engineer but it is correct to say that SMPS are inherently noisy. Linear Regulators, when properly designed are not.

That said, applying proper filtering and EMI reduction are key to proper product design. A good example is smartphones. They have multiple SMPS cohabiting with WiFi and other radio frequency devices all on a single (and tiny) pcb.

Generally speaking, PS requirements are based more on power and heat dissipation than EMI because you can always filter out noise but you can't eliminate heat.

Not sure if this helps or not...StackExchange or EEVBLOG Forum is probably a better place for this question.

Bu yanıt yardımcı oldu mu?

Puan 2
Yorum Ekle

Yanıtını ekle

AmandaLi sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 129