Backlight not working after LCD replacement
Hi all.
I know a few questions like this have been asked before, but I feel as though mine is slightly different.
The LCD was cracked, and I elected to replace it myself (as I've done many times before). Managed to get the old one off, turned it on and the back light was still on. Then turned the MacBook off, put on the new LCD, and in my haste, I think I plugged in the backlight cable to the PCB the wrong way around.
Now I get signal, but no backlight.
To my knowledge, this should of blown the fuse labelled 'P' on the logic board near the LDVS connector, but I checked that for continuity and it beeped. What else could it be? Where else shall I put my multi-meter? Could it be the backlight itself?
Any help would be appreciated!
Thanks!
Bu iyi bir soru mu?