İtibar: 1
1
Hi all, just attempted my first glass only repair on a Galaxy S5, and I thought that everything was going well, but I ended up with two vertical arcing light spots on either side of the screen, visible even with the power off. Could the heat have been too high? I had the hot plate set at 85C. Any input would be appreciated.
Here is a picture of the screen.
Bu iyi bir soru mu?
İtibar: 48,3b
7
66
97
Yes, you had the hotplate turned up too high. It should have been around 60-65C. I think you warped it.
Bu yanıt yardımcı oldu mu?
Well that's unfortunate. Most of the videos and articles I came across said 80-95. :(
Always check to see if the temperatures are in centigrade or fahrenheit
Which Temperature on LCD Separators is free of risks?
This thread is one of the ones I was referencing. The OP specifically asked for temperatures in C, and the first response was that 80 was standard.
http://gocellphonerepair.com/lcd-separat...
This artIcle goes so far as to say that they use 120C on Galaxy phones. Seems a long way off from 60-65C.
Not trying to challenge anyone or anything. I'm sure you are correct. Just wondering why so many others out there recommend temps that are so much drastically higher?
Let's put it this way. My hair dryer was around 65C, it worked perfectly. Higher temperatures require you to move extremely quick. Those who do this for a living I am sure can use 80C without damage, but if you keep that temperature at the same place too long, damage occurs.
Son 24 Saat: 0
Son 7 gün: 0
Son 30 gün: 0
Her zaman: 104
