Ana içeriğe geç

Repair information for Samsung clothes dryers.

10 Soru Tümünü görüntüle

Power but won't start

Samsung Dryer model DV45H700EW/A2 has power but won't start

Yanıtlandı! Cevabı görüntüle Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Puan 5
2 Yorum

Mine has power but won't heat

tarafından

@dcom03 Hi, Dana! There's more information available about your dryer's problem in the answer I just posted below. Check the link to the ifixit troubleshooting page there.

tarafından

Yorum Ekle

3 Cevap

Filtre ölçütü:
Seçilen Çözüm

It was the wheel that the belt goes around. It was melted and had fallen off.

Bu yanıt yardımcı oldu mu?

Puan 1
Yorum Ekle

Cause 1

Thermal Fuse

The thermal fuse is a safety device designed to protect the dryer from overheating. The fuse is located on the blower housing or at the dryer’s heat source such as the heating element on electric dryers or at the burner on gas models. The fuse should be closed for continuity meaning it has a continuous electrical path through it when good. If overheated the fuse will have no continuity meaning the electrical path is broken and the fuse has blown. A multimeter can be used to test it for continuity. Be aware that a blown thermal fuse is an indication of a restricted exhaust vent from the dryer to the outside. Always check the dryer venting when replacing a blown thermal fuse.

Cause 2

Start Switch

To determine if the start switch is defective, attempt to start the dryer. If the dryer hums but does not start, the start switch is not at fault. If the dryer does not respond or make any noise, the start switch could be at fault. Use a multimeter to test the start switch for continuity. If the switch does not have continuity, replace it.

Cause 3

Door Switch

The door switch activates when the dryer door is closed. On most dryers, the door switch makes an audible clicking sound when it activates. To determine if the door switch is working, try starting your dryer and then listen for the “click.” If the door switch makes a clicking sound, it is probably not defective. If you don’t hear a click, use a multimeter to use the door switch for continuity. If the switch does not have continuity, replace it.

Bu yanıt yardımcı oldu mu?

Puan 0

4 Yorum:

The dryer comes on and will run for about 10 seconds then shuts off

tarafından

The exhaust was clogged however it's all cleaned out now I'm just wondering is there a reset switch and what does de as a code mean?

tarafından

Unplugging it for10 minutes will allow it to reset.

tarafından

My electric dryer by Samsung DV50K8600EG-A3 will light up on the Control panel, has a clicking noise,and turns to 0 and cut off, but will not start up. What does this mean ?

tarafından

Yorum Ekle

Answer to Dana's comment above.

Check these items on your Dryer. The thermal cutoff, the Hi-Limit, and the Cycling Thermostat. Since your unit will start, the thermal fuse is good. For more detail go to the iFixit page, Electric Dryer Not Heating

Bu yanıt yardımcı oldu mu?

Puan 0
Yorum Ekle

Yanıtını ekle

Patricia Morris sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 14

Son 30 gün: 68

Her zaman: 38,203