Eşyalarını Tamir Et Topluluk Mağaza

Repair information and guides for the iPhone 6 that was released on September 19, 2014. Model Numbers: A1549, A1586, and A1589

4994 Soru Tümünü görüntüle

Seçenekler

iPhone 6 backlight Filter fl2024..

Hi Guys..

I m a beginner.. i m learning about smd board repair.

Anybody cuold explain me, how can i verify if the filter (For Example fl2024 - iphone 6) is ok or working properly? I often see the videos on youtube, somebody check them withmultimer in continuity mode or check OHM.

I want to know :

Which is the correct way to verify them?

Can i check it without battery , without on the phone?

Thanks a lot

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 0
Yorum Ekle

1 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
En Yararlı Yanıt

Seçenekler

Hi, to test a filter what you need to do it get a multimeter and put it in continuity mode (This is also called diode mode I believe). All filters should have continuity through them so if you put any probe on one side of the filter and then the other probe on the other side you should hear a beep meaning that both sides of the filter receive a signal. If you don't have that beep then the filter is faulty or it's not properly connected to the pads. Hopefully, that helped

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 2

2 Yorum:

And yes you don't have to plug the battery in

tarafından

Thanks a lot TOm... :)

tarafından

Yorum Ekle

Yanıtını ekle

Umer Muhammad sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 1

Her zaman: 861