Ana içeriğe geç

Aren't there supposed to be two wires connecting to the battery holder

I am trying to repair a Chantilly Singing Bear. The batteries were corroded inside the battery holder, so I cleaned it out with baking soda, but still it doesn't work. Opened it up and noticed on the red wire is attached to the battery holder, and there is a loose black wire just dangling from the circuit board not connected to anything. Isn't there supposed to be both a red and black wire connecting to it? Also, general tips on how to connect the wire back would be appreciated. I am very new to this.

Block Image

Block Image

Yanıtlandı! Cevabı görüntüle Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Puan 1
Yorum Ekle

2 Cevap

Filtre ölçütü:
Seçilen Çözüm

@rblack connect the black wire (blue arrow) to the tab (red arrow) by soldering it. Use this guide to learn about soldering How To Solder and Desolder Connections

Bu yanıt yardımcı oldu mu?

Puan 2
Yorum Ekle

yes the black wire should be connected

Bu yanıt yardımcı oldu mu?

Puan 0
Yorum Ekle

Yanıtını ekle

RBlack sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 3

Her zaman: 242