Eşyalarını Tamir Et Topluluk Mağaza

25 Eylül 2015'te yayımlandı. A1688/1633 modeli. Bu cihazın tamiri eski nesillerinkine benzer; tornavida ve kaldırma aletleri gerektirir. GSM ya da CMDA olarak / 16, 32, 64 yada 128 GB kapasiteli / Gümüş, Altın, Uzay Grisi yada Rose Gold (Gül Altın) seçenekleri mevcuttur.

2689 Soru Tümünü görüntüle

Seçenekler

Toggling Silent/mute switch doesn't work. Then mutes/unmutes by itself

My iphone 6s mute/silent switch doesnt respond correctly when I toggle it. Switch seems to be working fine mechanically (been cleaned as much as possible from the outside).

Further, the mute/silent function changes on its own. Sometimes ever couple seconds (even though switch not moving).

Seems the audio/power cable (and bracket) need to be replaced. Does the button also need to be replaced? Anyway I can open it up and the solution will be simpler?

Yanıtlandı! Cevabı görüntüle Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 0
Yorum Ekle

1 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
Seçilen Çözüm

Seçenekler

It definitely sounds like the button on the flex is damaged. You can change this yourself.

This is not the simplest DIY repair so if you're all thumbs, I wouldn't recommend it as a lot can go wrong here. If you're a good fixer in general and have a delicate touch, you should certainly try it. The repair guide is here.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 5

5 Yorum:

YES! I saw that. Thank you. So I dont have to replace the mechanical switch? Just the cable and bracket?

tarafından

The physical actuator is on the flex. The button you push only pushes itself against the actuator.

tarafından

I understand. Is it possible there is just a poor connection/dirt between the actuator and the button? Or does the flex definitely need replacing?

tarafından

It's possible, sometimes it can get out of alignment. You'll have to open it up and take a closer look.

tarafından

When I order the volume button cables I usually make sure it comes with the metal bracket and the vibrate switch attached with the metal bracket too.

What generally happens is that the plastic 4 holes gets loose from the metal bracket for the switch making it hard to switch or getting stuck in a certain position.

A worn out switch or teared ribbon cable may cause the vibrate switch to go on and off randomly.

tarafından

Yorum Ekle

Yanıtını ekle

Adam Comis sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 278