Ana içeriğe geç

25 Eylül 2015'te yayımlandı. A1688/1633 modeli. Bu cihazın tamiri eski nesillerinkine benzer; tornavida ve kaldırma aletleri gerektirir. GSM ya da CMDA olarak / 16, 32, 64 yada 128 GB kapasiteli / Gümüş, Altın, Uzay Grisi yada Rose Gold (Gül Altın) seçenekleri mevcuttur.

2682 Soru Tümünü görüntüle

iPhone not charging and 0 Amps

Hi, I received an iPhone 6S from a customer that said that their screen and battery need replacing. I replaced both of those but when you turn the phone on it boot loops. I plugged it into a USB ammeter and I’m getting 5V and 0.25 amps being drawn when not turned on which looks like it’s charging the battery but when you turn it on it boots but doesn’t charge. It drops to 0 amps when booting and the CPU area gets slightly hot but stops when booted. When not plugged into a charging cable and boot looping the CPU area gets really hot.

Would appreciate the help Thanks

@refectio

Yanıtlandı! Cevabı görüntüle Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Puan 0
Yorum Ekle

2 Cevap

Filtre ölçütü:
Seçilen Çözüm

Do you know the history of the device? If it was dropped, repaired, came into contact with water or if the customer was using cheap chargers, then that would help you in your troubleshooting.

I agree with A1, try isolating the logic board with a known-good battery and Lightning Port. If it still doesn’t boot, then you definitely have a board level issue. Depending on the history, you could focus on the charge circuit, or probe the PMIC/BBPMU and main voltage rails for additional clues.

Bu yanıt yardımcı oldu mu?

Puan 2

1 Yorum:

I have done some further tests and have managed to boot the phone on a good known battery however the phone doesn't charge at all. When plugged into a charger it doesn't charge the battery and it keeps on dropping at a normal pace. I have ordered a new charging flex and the history of the phone is not known but it looks like the phone was dropped heavily on the front looking at the cracks on the screen. Thanks for the help

tarafından

Yorum Ekle
En Yararlı Yanıt

I would start with doing an isolation test disconnecting cameras and flexes.

If issue is still there I would say Tristar could be the cause.

Bu yanıt yardımcı oldu mu?

Puan 2
Yorum Ekle

Yanıtını ekle

Tom sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 4

Son 30 gün: 25

Her zaman: 1,403