Ana içeriğe geç

Trying to figure out what this part is.

Block Image

Block Image

Block Image

Block Image



This part is to the carburetor for a 83 Yamaha XJ750. I’m thinking it’s a Jet however I’m having no luck finding something that looks the same or has the same numbers on it.


It’s the part under the diaphragm. It almost looks like a jet.


The numbers on the top of the part are 2 2 5. Also I accidently stripped one while trying to take it out. How would you recommend I get that out?

If I could get an answer as to what this is, that would be amazing! Thank you.

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Puan 0
Yorum Ekle

1 Cevap

Filtre ölçütü:
En Yararlı Yanıt

If this were my carburetor and I absolutely had to remove the jet, I would put a good quality penetrant like aerokroil on the stuck jet. Make sure to remove all plastic and rubber parts from carb body. Then I would heat it to 300-400 degrees F in and oven and try to get the jet moving with an easy out of the appropriate size. These tools have a clockwise spiral to them and flutes that will engage the brass of the jet body. You must tap them into the opening to get them engaged enough to allow the jet to be unscrewed. If you tap them too hard or deep into the jet it will just expand the jet body and make it even harder to remove. Take it easy and don’t ruin the entire carburetor body. Order a new jet of the appropriate size since you won’t want to reuse it after this abuse. Also, this is some sort of air bleed jet since it is inside the CV slide cavity which is an air only area of the carburetor body.

Bu yanıt yardımcı oldu mu?

Puan 2
Yorum Ekle

Yanıtını ekle

Leon sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 120