Seçenekler

My Washer fills then does wash cycle , drains but does not fill again.

I only have one water source cold water. The first indication of trouble was it would not fill up with water. So I checked the filter screens, which were clean then I changed the water connection to the hot water input and selected hot water on the control panel. after this it filled normally. then washed one cycle and would not refill on it’s own.

I can fill washer with the garden hose at this point and it will continue the rinse cycle

Yanıtlandı! Cevabı görüntüle Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır

Puan 1

3 Yorum

Did it empty and fill than empty again befor

Darkened wolves tarafından 17 Şub 2019

I am not sure but I will pay attention and add a note . Thanks for taking the time to post

David Major tarafından 17 Şub 2019

Kenmore model 110

David Major tarafından 21 Şub 2019

Yorum Ekle

Gönderildi: 18 Şub 2019

Seçenekler

Hi @yoclem ,

You may have a problem with the cold water inlet solenoid in the washer.

Don't know your washer but on some when you select a hot water wash, on the wash (agitate) part of the cycle you get a hot water wash but not a hot water rinse which follows the wash, it is cold water. There may be only one wash type option (mostly wool wash -if you have it) that has a hot (or warm - hot and cold) rinse.

Check the user manual for your model to see what the rinse cycle temperatures are for each wash type option (regular, heavy, delicates etc) that you have.

If one of them has a hot (or warm) water rinse as part of the cycle try running that wash cycle with the water connected to the machine’s hot water inlet. If it fills for the rinse part of the cycle it points to a problem with the cold water solenoid.

What is the full model number of the washer?

Bu yanıt yardımcı oldu mu?

Evet Hayır

Puan 3

Yorum Ekle

Kenmore 400 Washer

My Washer fills then does wash cycle , drains but does not fill again.

1 Cevap

Yanıtını ekle