I have a 27” iMac mid 2011 and suddenly the display went blank.
I checked the onboard diagnostics and LED 3 and 4 are off.
I purchased a new graphics card and logic board but now the same problem. LED 1 and 2 turn are on and LED 3 and 4 are off. What is the solution ?
Bu iyi bir soru mu?
İtibar: 25
3
Information directly from the source:
LED 3
Indicates that computer and video card are communicating. This LED will be ON when computer is communicating properly with video card. If LEDs 1 and 2 are ON and you heard the startup sound, but LED 3 is OFF, then the backup battery (on front of logic board) may need to be reseated, or the video card might be installed incorrectly or needs replacement.
LED 4
Indicates that computer and LCD panel are communicating. This LED will be ON when computer is turned on and video signal is being generated. If LED 4 is ON and there is no image on display, then LCD panel, LED backlight board, or cables between LCD and logic board or backlight board might be installed incorrectly, or need replacement.
Bu yanıt yardımcı oldu mu?
Son 24 Saat: 0
Son 7 gün: 1
Son 30 gün: 2
Her zaman: 73
2 Yorum
Check your cables, its also possible you got a bad logic board/GPU
Dan tarafından
yeah i did that too. its a new logic board and gpu but led 3 is still off.
james tarafından