Eşyalarını Tamir Et Topluluk Mağaza

Apple's 6th revision to the iPod Touch lineup, released in July 2015.

149 Soru Tümünü görüntüle

Seçenekler

New Battery, apple logo blinks on and off, but doesn't boot.

So, I followed the incomplete guide to solder in a new battery, and it worked!

But now when I try to turn it on (before I fully close it up and get everything going again) it starts with the apple logo, stays there for maybe half a second, goes black, and repeats the process until I press the power button to turn it off again.

What do I do?


Additional info: I used flux.

(as a note, but not relevant to the question, I did poke my screen a bit, so it’s “damaged”, but functional. It’s like a wrinkle under the glass, on the side.)

Yanıtlandı! Cevabı görüntüle Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 0
Yorum Ekle

1 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
Seçilen Çözüm

Seçenekler

Are you certain the connections on the flex and connection were in line when you soldered them? If so, it’s going to be either a bad battery or further component damage. The easiest way to diagnose this issue is to try again with a known good battery.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 1

1 Yorum:

It was componant damage. I burnt a copper pad.

So, I screwed up, but you had the right answer. Thank you for trying!

It was my first solder job, so it's to be expected I'd make mistakes. I didn't think I'd make one that BIG, though.

tarafından

Yorum Ekle

Yanıtını ekle

No_ sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 gün: 1

Son 30 gün: 6

Her zaman: 34