Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

Model A1136 / 30, 60, or 80 GB hard drive / black or white plastic front

907 Soru Tümünü görüntüle

Why doesn't work the backlight of my iPod?

Hi everyone!

This is a big problem for me because I love this iPod. The ,,back” button (left button) under the clickwheel was broken. I have a donor motherboard so I just replaced the broken button. I tested the iPod after the button replacement work and everything was fine then I put the motherboard in my ultrasonic cleaner because I used flux. After the ultrasonic cleaning the backlight didn’t work. I tried with an another display but the situation is same.

I need a schematic to the repair or any advice that where can I find the backlight circuit.

Please don’t write that: ,,Just buy an another motherboard”. This isn’t worth It and I just want to repair this iPod.

Thanks in advance to the replies.

Yanıtlandı! View the answer Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Puan 0
Yorum Ekle

TÜM SEKMELERİ AÇ

Mac için RAM Yükseltme Kit'leri

Kit Satın Al

Tüm Sekmeler İçin Yeterli RAM

Kit Satın Al

1 Cevapvvbh

Filtre ölçütü:
Seçilen Çözüm

@karl67 schematics for the iPod are not available. Since you have a donor board you would have to go and measure the components and see if you find the one that has shorted out. I would focus on the coil around the display connector. If you have a meter you can check pin 30 which should be Backlight -Neg and pin 31 +Pos there will be a boost circuit to get the backlight voltage (again check for shortened out coil)

Bu yanıt yardımcı oldu mu?

Puan 0

Yorumlar:

Thank you for the answer! I will check the pin 30.

tarafından

Yorum Ekle

Yanıtını ekle

Norbert Jauch sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 19

Her zaman: 19