Eşyalarını Tamir Et Topluluk Mağaza

The GameCube is Nintendo's fourth console gaming system. Repair is simple and requires only common tools.

91 Soru Tümünü görüntüle

Seçenekler

Disks won't spin after replacing the laser

I just replaced the laser in an old gc, and it's moving, but the disk isn't spinning up. Not sure if that was already happening or if it's a new problem though. What can I try now?

Block Image

Update: took it apart again to check for that solder ball, and now the disc spins, but the laser doesn't turn on

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 0
2 Yorum

@sadmango, Did you remove the solder ball all lasers are supposed to be shipped with to make it transport safe?

tarafından

no, i didn't know there was one

tarafından

Yorum Ekle

2 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
En Yararlı Yanıt

Seçenekler

Go back over the connections you disconnected and make sure they are all connected correctly.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 1
Yorum Ekle

Seçenekler

Did you get rid of the solder that you need to take off?

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 1

3 Yorum:

I don't think there was any. I'll add a pic in case it's just me being dumb

tarafından

@sadmango Ok, Thanks

tarafından

@sadmango That cable looks burnt?

tarafından

Yorum Ekle

Yanıtını ekle

just some mango sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 1

Son 30 gün: 4

Her zaman: 100