Eşyalarını Tamir Et Topluluk Mağaza

Model No. A1367 / 8, 16, 32, or 64 GB capacity

914 Soru Tümünü görüntüle

Seçenekler

Black screen after replacing flex cable. [SOLVED]

[THE PROBLEM]

I ran into an issue in the shop where after replacing the Flex cable every screen I tried was black. The iPod wouldn't even beep when plugged in.

Since I googled the tar for a solution, and couldn,' find one, I'll post what I found for anyone else with the same problem who hasn't been able to find a solution.

The solution is moved below, to the answer so that it can be cleared per request.

Yanıtlandı! Cevabı görüntüle Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 2
2 Yorum

Please use the last paragraph as an answer and accept it to clear the question.

tarafından

Thanks for letting me know guys, I did as you suggested.

tarafından

Yorum Ekle

1 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
Seçilen Çözüm

Seçenekler

[HOW TO FIX IT]

I covered the circuits around the flex cable and de-solder it then cleaned up the pads and soldered on the new flex.

Not adhering to my own soldering instructions, of course I got in a rush and did this without de-soldering the + terminal on the battery first.

In my case, I went back and disconnected the + terminal on the battery and soldered it back on. The black screen went away and the iPod kicks up just fine.

I hope this helps fellow techs that may have found this.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 3
Yorum Ekle

Yanıtını ekle

Country Computer Service sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 2

Her zaman: 3,294