Ana içeriğe geç

Fourth generation iPhone. Repair is straightforward, but the front glass and LCD must be replaced as a unit. GSM / 8, 16, or 32 GB capacity / Model A1332 / Black and White. This page aims to help users troubleshoot, fix, and seek help for the iPhone 4.

2375 Soru Tümünü görüntüle

How do I recover my screen after I laundered my I-phone?

Four days ago, my new I-phone went through the laundry for 15 minutes. The battery was flat, and the phone was off. I immediately removed the sim card and battery and ran a hair dryer at low heat on it for fifteen minutes, then left it in rice. I alternated hair dryer and rice for three days, then tried the phone.

The battery has fully recharged. The sounds I hear from the phone suggest that it is operating, but nothing is visble at all on the screen.

Is there anything I can do short of replacing the phone?

P.S. I am in France where I have a language handicap. Thanks for your help!

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Puan -1
1 Yorum

Thanks, "I-fix-it", I will try this tonight.

tarafından

Yorum Ekle

2 Cevap

Filtre ölçütü:
En Yararlı Yanıt

Dan Miller, "the first thing I would suggest is that you clean your phone. The rice is a great first step, but it will not fix your phone, nor will it prevent corrosion damage which might occur later on. Use this guide to clean your phone. It was written for a 3G but it will still pertain to your phone as well. The repair guides for your phone are here. After that you want to check this "There is really no a surefire way to say which part is the one that gives you the problem. I would recommend that you start it systematically. Start with the easiest part, and that is the display, replace that. If your screen is absolutely black, with no faint images, I am certain that this is your problem. If it would have faint images, I would recommend to take a look at the backlight IC and coil on the logic board. That repair is a bit more difficult due to the fact that those are SMD components." It's kind of (in a very simplistic description) the LCD is your light bulb and the backlight IC and coil are your light switch. Also check this question and multiple more on here. Try the display first. Hope this helps, good luck."

Bu yanıt yardımcı oldu mu?

Puan 1
Yorum Ekle

Probably your screen died. Replacing the display assembly may solve your problem.

Bu yanıt yardımcı oldu mu?

Puan 0
Yorum Ekle

Yanıtını ekle

Dan Miller sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 1

Son 30 gün: 1

Her zaman: 497