Camera Board Replacement
3 sayfa · 6.76 MB · PDF
Roku Indoor Camera 360 SE (CP1000X) - Camera Board Replacement
Introduction
This guide covers removing the camera board assembly (DF3V2-LEDP01 V1.0 + DF3V2-SENSOR-V2.1) from the camera head.
Prerequisites
-
Complete the Back Panel Replacement guide first.
-
Complete the Camera (Tilt) Motor Replacement guide first.
-
Complete the Camera Mounting Bracket Replacement guide first.
What you need
Small Phillips screwdriver
Step 1 - Remove the camera board screws
The black camera board is secured with 4 screws. Remove all four. The red circles below show their locations.
Camera Board Screws Overview
DF3V2-LEDPO1 V10
Camera Board Screws Detail
Two additional screws are located near the FPC connector area.
