3. Disassembly and reassembly
3-1 Disassembly of main unit
-
Remove the two SCREWS on the right side, two SCREWS on the left side, two SCREWS on the bottom side.
-
Insert open pry tool around the join of locking structure part to release the ASSY COVER BACK as illustrated in image below.
-
Remove the ASSY COVER FRONT with ASSY COVER BACK.
4. Remove the four SCREWS of ASSY COVER FRONT.
5. Remove the ASSY DECO RING.
- Discharge.
CAUTION
It must be processed for discharge to the main condenser as shown in the below picture.
-
Remove the one SCREW of ASSY-KEY_FPCB.
-
Flip over direction of the right a ASSY LCD.
-
Remove the two FPCB as illustrated in " Fig. A", " Fig. B".
CAUTION
Use extra care when removing the FPCB from the connector.
11. Remove the three SCREW.
12. Remove theASSY FRAME-MAIN.
- Remove the WI-FI antena and FPCB adhesion part as illustrated in " Fig. C".
- Remove the FPCB from the CONNECTOR as indicated in " Fig. D", " Fig. E".
CAUTION
Use extra care when removing the FPCB from the connector.
- Remove the ASSY-BARREL MAIN PCB.
16. Remove the T/SHEET-FPCB A.
!
CAUTION
Make sure to attach the T/SHEET-FPCB A not to cause the surface malfunction.
17. Remove the two FPCB from the connector as illustrated in "Fig. F", "Fig. G".
18. Remove the ASSY BARREL and ASSY PCB MAIN.
- Remove the MAIN CONDENSER.
- Use a tweezers at locking of part shown in five green circle of COVER TOP and remove it.
- 21 . Remove the two solder marked in red circle as illustrated in "Fig. H".
23. Remove the SPEAKER ASSY.
24. Remove the three SCREWS.
Fig. 3-23
- Remove the following parts in the order indicated below.
- ① CCD FPCB ASSY
- ② CCD RUBBER
③ IR CUT
①
CCD FPCB ASSY
②
CCD RUBBER
③
IR CUT
7. Remove the BARREL-OUTER GUIDE.
8. Remove the BARREL-OUTER CAM.
- Remove the BARREL-OUTER GUIDE PLATE.
- Remove the BARREL-CAM.
11. Remove the BARREL-ZOOM RING.
- Remove the SUB BARREL ASSY-2ND.
Fig. 3-32
3-3 Reassembly of barrel
3-3-1 How to use the lubricant for anti-friction to the ASSY BARREL assembly.
- ■ Anti-friction lubricant serves to prevent from the possibility of defective parts.
- ■ Replacement parts are required to apply the lubricant before installing the ASSY BARREL.
CAUTION
- ■ HANARL is volatile product. Keep its container tightly covered.
- ■ Make sure to shake the HANARL well first before you use it because it has a lot of particles in the bottom. (Otherwise it becomes ineffective.)
- ■ Shake the HANARL until there are no lumps at all and apply it with brush.
1. Type of lubricant
<Table. 3-1 lubricant Information>
| Component Name | Where to apply | Name of lubricant |
|---|---|---|
| Lens Base | Sliding contact surfaces of AF Lens. | Grease KG-513 |
| Others components | Inside and outside friction surface | HANARL UD-420K |
**Table Caption: This table outlines the specific lubricants recommended for different components of a device. The Lens Base's sliding contact surfaces require Grease KG-513, while other
