Quick Setup

Before using the projector, make sure you read the safety instructions in the User's Guide on your projector CD.

Connect the projector

Choose from the following connections:

Computer Monitor Port

Connect a computer using the VGA cable that came with the projector.

O

Connect one end to the projector's Computer port, and the other end to your computer's □ monitor port. If you are using a notebook, switch it to external display.

Computer USB Port

Connect a computer (Windows $ ^{\circledR} $ 2000 or later, 32-bit only) to the projector using a USB cable.

Connect the square end of the USB cable to the projector's USB TypeB port. Connect the flat end of the cable to any USB port on your computer.

Computer Type

After turning on the projector, follow the on-screen instructions to install the Epson USB Display software. (You need to install the software only the first time you connect.) Then press the USB button on the remote control to select the image source.

Video Device

Connect up to 3 video devices and use the remote control to switch between them.

RCA video cable (composite video) (optional) S-Video cable (optional) Computer cable (included) Video S-Video RS-232C Computer TypeB USB

Turn on your equipment

1 Turn on your computer or video source.

2 Plug in the projector.

The power light on the projector turns orange.

3 Open the A/V Mute slide all the way.

←

4 Press the ☐ power button on the projector or remote control.

Temp Lamp

The projector beeps, the power light flashes green, and then stays on.

NOTE: To shut down the projector, press the ⏚ power button twice, then unplug it. You don't have to wait for the projector to cool down.

Adjust the image

If you don't see an image, press the Source Search button on the projector or remote control to select the image source.

NOTE: If you still see a blank screen or have other display problems, see the troubleshooting tips on the right.

2 To raise the image, press the foot release button and lift the front of the projector. Release the button to lock the foot in position.

↑

3 Turn the focus ring to sharpen the image, and the zoom ring to enlarge or reduce it.