Ana içeriğe geç

NN SD27HS

33 sayfa · 4.94 MB · PDF

Specification

ModelsSD28HS GTGSD27HS BPQIUPGIGTGSD26HM BPQSD2SHB BPQ
Power Source:230V AC Single Phase; 5OHz For UPG,GTG models 230V-240V AC Single Phase; 5OHz For BPQ models
Power Consumption:
Output:
Microwave Frequency:2450MHz
Timer:90 min.OOsec (HIGHIMAX Power Level) 30 min. OOsec (Other Power Level)
Outside Dimensions:488mm(W) x 395mm(D) x 279mm(H)
Oven Cavity Dimensions:315mm(W) x 353mm(D) x 206mm(H)
Weight:9.5kg
PbFThis product with PbF
Specifications subject to change without notice.

Table Caption: This table provides a side-by-side comparison of four different microwave models, detailing their specifications such as power source, microwave frequency, timer limits, external and internal dimensions, and weight. All listed models appear to have identical dimensions and weight, and all are described as containing "PbF".

©

Panasonic

Appliances

Microwave

Oven

(Shanghai) Co., Ltd. 2017.

Microwave Oven

NN-SD28HS

NN-SD27HS

NN-SD26HM

NN-SD25HB

BPQ (U.K.)

UPG (France)

GTG (Northern Europe, Germany)

WARNING

Products powered by electricity should be serviced or repaired only by experienced professional technicians. attempt to service or repair the product or products dealt with in this service information by anyone else could result in serious injury or death. Any

This service information is designed for experienced repair technicians only and is not designed for use by the general public. It does not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product.

WARNING

  • 1.This product should be serviced only by trained, qualified personnel.

  • 2Check for radiation leakage before and after every servicing according to the "procedure for measuring radiation leakage:'

  • 3.If the unit cannot be repaired on site, advise the customer not to use until unit is repaired.

  • 4.There are special components used in the microwave oven which are important for safety: These parts are marked with on the replacement parts list. It is essential that these critical parts be replaced only with the manufacture's

This service manual covers products for following markets.

When troubleshooting or replacing parts, please refer to the countrylarea identifications shown below for your applicable product specification.

BPQ For UK

UPG For France

GTG For Northern Europe; Germany

About lead free solder (PbF)

Caution:

CAUTION

Distinction of PbF PCB: PCBs (manufactured) using lead free solder will have a PbF stamp on the PCB.

  • Pb free solder will tend to splash when heated too high (about 600*C).
  • Pb free solder has a higher melting point than standard solder; Typically the melting point is 30 40*C higher. Please use a high temperature soldering iron: In case of the soldering iron with temperature control; please set it to 370 + 10 C.

DANGER OF HIGH VOLTAGE AND HIGH TEMPERATURE (HOTILIVE) OF THE INVERTER POWER SUPPLY (U)

INVERTER WARNING

This Inverter board looks like a regular PCB. However, this PCB drives the magnetron tube with extremely high voltage and high current. Improper handling can result in an electrical shock or burns, which might lead to injury or death.

  • IT HAS: 1 high voltage and high current circuits. It functions the same as the high voltage transformer and high voltage capacitor in ordinary microwave ovens. Very
  1. Very high voltage which may remain in circuitry even when oven is off. High voltage charge may remain in the capacitors on the board.

DO NOT:

  1. Aluminum heat sink that is energized with very high voltage and high heat energy.
  2. 1 care should be taken to avoid possible electric shock hazards. High voltage charge may remain in circuits.
  3. Do not touch aluminum heat sink because it is energized with very high voltage and is also very hot in high heat energy.
  4. Do not try to adjust or tamper with preset control on the Inverter board because it is very dangerous to adjust without proper test equipment.
  5. Do not test oven while Inverter grounding plate or screws are loose. It is very dangerous to operate H.V. Inverter Circuit (U) with loose mounting screws or if improperly grounded.

INVERTER POWER SUPPLY

CONTENTS

Page
1 FEATURE CHART5
2 CONTROL PANEL5
3 SCHEMATIC DIAGRAM6
4 DESCRIPTION OF OPERATING SEQUENCE7
4.1. Variable power cookingcontrol 7
4.2. Inverter power supply circuit7
4.3. Inverter defrost, Auto menu & Autoreheat 7
5 CAUTIONS TO BE OBSERVED WHEN TROUBLESHOOTING8
5.1. Check the grounding8
5.2. Inverter warnings8
5.3.Part replacement. 9
5.4. When the 10A shortfuse is blown due to the malfunction of the switch: 9
5.5. Avoid unit duringoperation. 9
5.7. Sharp edges
5.6. Verification after repair9
9
6 DISASSEMBLY AND PARTS REPLACEMENT PROCEDURE 10 6.1. Magnetron10
6.2. Digital programmer circuit(D.P.C) 10
6.4. DC fan motor11
6.5. Door assembly12
6.6. Turntable motor13
6.7. H.V. Inverter Power Supply14
7 COMPONENT TEST PROCEDURE15
7.1. Primary, Secondary Latch Switch interlocks &Power
Relay RY1
15

Table Caption: This table is an index or table of contents for a service manual, listing sections, their corresponding page numbers, and some sub-sections or related details. It guides the user through various aspects of the product, from features and operation to troubleshooting and parts replacement.

Table Caption: This table is a table of contents or index for a technical manual, listing sections, their titles, and corresponding page numbers. It covers topics from component descriptions to troubleshooting and parts lists.

1 FEATURE CHART

MODEL FEATURESD28HSSD27HSSD2GHMSD2SHB
3 Stage Cooking
Microwave
Auto Weight Cook
Auto Weight Chaos Defrost
Timer
Clock
Aqua clean
Child Safety Lock

Table Caption: This table compares the features of four different microwave models: SD28HS, SD27HS, SD2GHM, and SD2SHB. It indicates the presence or absence of features such as 3 Stage Cooking, Microwave, Auto Weight Cook, Auto Weight Chaos Defrost, Timer, Clock, Aqua clean, and Child Safety Lock for each model.

2 CONTROL PANEL

Beep Sound:

When a button is pressed correctly; a

Belgenin tamamını okumak için iFixit’e ücretsiz üye olun (33 sayfa)

Botları engellemek ve iFixit’i insanlar için korumak amacıyla ücretsiz bir hesap açmanız gerekmektedir.