2011 Jeep Liberty Hood Replacement

Giriş

Replacing a 2011 Jeep Liberty hood is a moderately simple task, requiring only a single tool. It is recommended to have two people complete the replacement, though it is not a requirement. There are no special skills required for this replacement. Replacing the hood is usually a cosmetic choice but may be needed if the hood is misshapen and will not longer function with the vehicle.

Neye ihtiyacın var

Adım 1 Hood

2011 Jeep Liberty Hood Replacement, Hood: adım 1, 1 resimden 1.

Open the hood of the Jeep by pulling the hood latch. This is placed right next to the driver's seat and to the left of the brake pedal.

Düzenle

Adım 2

2011 Jeep Liberty Hood Replacement: adım 2, 3 resimden 3.

Notice a latch located above the car's grill after popping the hood. Lift the hood by releasing the latch. After lifting the hood, notice a movable latch just above the wiper fluid container. There is a specific hole on the left side of the hood where you can hook the latch.

Düzenle

Adım 3

Disconnect the wind-shield fluid line on the left side of the hood.

Düzenle

Adım 4

Identify the four bolts which can be seen towards the extreme left (2 bolts) and extreme right (2 bolts) underneath the hood.

Düzenle

Adım 5

Remove the four bolts using a 13mm wrench and lift the hood out of place.
After replacing the old hood with the new hood, reverse the process; tighten back the four bolts and connect the wind-shield fluid line.

Düzenle