Eşyalarını Tamir Et Topluluk Mağaza

3DR Solo Leg Replacement

Giriş

This guide shows how to remove the legs on the bottom of the drone.

Neye ihtiyacın var

  1. 3DR Solo Leg Replacement, Propeller: adım 1, 1 resimden 1.

    • Grip the arm, which is located underneath the propeller, with one hand, and with your dominant hand grip the center of the propeller.

    Düzenle

  2. 3DR Solo Leg Replacement: adım 2, 1 resimden 1.

    • Twist the propeller from the locked to unlocked position as indicated by the images of the lock.

    • You will need to twist in this direction for 2-3 full rotations before the propeller will detach.

    Düzenle

  3. 3DR Solo Leg Replacement: adım 3, 1 resimden 1.

    • Lift the propeller off the motor.

    • To remove the silver-top propellers, repeat these steps, turning the propellers in the opposite direction of the black-top propellers.

    Düzenle

  4. 3DR Solo Leg Replacement, Leg: adım 4, 1 resimden 1.

    • Place the controller on a flat surface with the battery side down.

    Düzenle

  6. 3DR Solo Leg Replacement: adım 5, 3 resimden 1. 3DR Solo Leg Replacement: adım 5, 3 resimden 2. 3DR Solo Leg Replacement: adım 5, 3 resimden 3.

    • Locate the leg and remove the two 10mm screws that hold the leg in place.

    Düzenle

  7. 3DR Solo Leg Replacement: adım 6, 1 resimden 1.

    • Gently pull the leg up to remove it from its position.

    • Leg should be connected by a black wire.

    Düzenle

  8. 3DR Solo Leg Replacement: adım 7, 3 resimden 1. 3DR Solo Leg Replacement: adım 7, 3 resimden 2. 3DR Solo Leg Replacement: adım 7, 3 resimden 3.

    • Locate the rubber grip at the end of the leg and, with your thumb, peel it back and pull it off.

    Düzenle

  9. 3DR Solo Leg Replacement: adım 8, 2 resimden 1. 3DR Solo Leg Replacement: adım 8, 2 resimden 2.

    • Leg type 1 will contain a 1mm screw at the base of the leg.

    • Unscrew the 1mm screw located at the end of the leg.

    Düzenle

  10. 3DR Solo Leg Replacement: adım 9, 1 resimden 1.

    • Gently pull the black cord up to release it from the leg.

    Düzenle

  11. 3DR Solo Leg Replacement: adım 10, 3 resimden 1. 3DR Solo Leg Replacement: adım 10, 3 resimden 2. 3DR Solo Leg Replacement: adım 10, 3 resimden 3.

    • Leg type 2 will contain the antenna wire.

    • Gently pull up on and remove the plastic covering labeled "solo antenna".

    • Locate the antenna wire and carefully pull up and remove it.

    • The antenna wire is flimsy so use caution upon removal.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Yazar

3 tane daha katılımcı ile

Leia Harlow

Üyelik tarihi: 09/11/17

101 İtibar

1 Kılavuz yazıldı

Rozetler: 4

+1 tane daha rozet

Ekip

CSU Fullerton, Team S2-G3, Bruce Fall 2017 CSU Fullerton, Team S2-G3, Bruce Fall 2017 üyesi

CSUF-BRUCE-F17S2G3

4 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 3

Her zaman: 324