1. Lift the screw cover and remove the screw using a Phillips #0 screwdriver.
    • Lift the screw cover and remove the screw using a Phillips #0 screwdriver.

  2. Remove the RAM cover by lifting the screw cover and pulling away firmly.
    • Remove the RAM cover by lifting the screw cover and pulling away firmly.

    • Push outwards on the clips to release the RAM stick. The stick should pop up at an angle.

    • Pull out the RAM stick carefully.

    • Do not use a prying motion as this will damage the hardware. Be careful not to damage the gold section of the RAM stick.

    • Repeat steps 3-4 to remove the second RAM stick.

    • Gently pry the back hinge cover piece away from the device.

    • Disconnect the speaker cable from the motherboard.

    • Remove the two screws from underneath the RAM cover.

    • Remove all of the screws from the bottom of the case.

    • If replacing the screen, remove the rubber feet to reveal two more screws.

    • Turn the laptop over and remove the screws as shown

    • Carefully pry the keyboard away using your spudger and the opening tools.

    • Be sure not to damage the clips holding the keyboard to the bottom case.

    • Detach the ribbon cable by releasing the clip

    • With the motherboard exposed, locate the Indicator Lights and their white plastic housing piece.

    • Remove all 3 screws from the motherboard connection using the Phillips #0 screwdriver.

    • Pull the plastic white housing piece away from the case.

    • Locate the flat LED cable that connects the lights to the motherboard.

    • Flip the black cover upwards before pulling on the cable.

    • Repeat for the other connector piece.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Nicolas Catano

Üyelik tarihi: 24-09-2018

104 İtibar

1 Kılavuz yazıldı

0 Yorum

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 3

Son 30 Gün: 20

Her zaman: 35