Alcatel One Touch Evolve 2 Main Circuit Board Replacement

Giriş

This guide serves as a prerequisite guide to replacing the front speaker, front camera, headphone jack, and charging port of an Alcatel One Touch Evolve 2 phone.

Neye ihtiyacın var

Adım 1 Back Frame

Alcatel One Touch Evolve 2 Main Circuit Board Replacement, Back Frame: adım 1, 3 resimden 1.

Alcatel One Touch Evolve 2 Main Circuit Board Replacement, Back Frame: adım 1, 3 resimden 2.

Alcatel One Touch Evolve 2 Main Circuit Board Replacement, Back Frame: adım 1, 3 resimden 3.

Turn off the phone before proceeding with disassembly to prevent shock and potential shorting of any electrical somponents.
Remove the back cover using one of the plastic opening tools and the slit in one of the corners.
Be gentle when prying so as to not wear out the tool.

Düzenle

Adım 2

Remove the battery using one of the plastic opening tools and the dome-shaped indent next to the battery face.

Düzenle

Adım 3

Unscrew the four 4mm JIS screws in each corner using the J000 screwdriver head. Turn the screws counter-clockwise to loosen.

Düzenle

Adım 4

Alcatel One Touch Evolve 2 Main Circuit Board Replacement: adım 4, 3 resimden 3.

Insert a plastic or metal spudger between the front cover and rear frame in one of the areas indicated by the red squares and gently pry the rear frame loose. Repeat the process all the way around the phone until the rear frame comes loose.

Düzenle

Adım 5

Pull the rear frame off with your hands.

Düzenle

Adım 6 Main Circuit Board

Alcatel One Touch Evolve 2 Main Circuit Board Replacement, Main Circuit Board: adım 6, 2 resimden 1.

Alcatel One Touch Evolve 2 Main Circuit Board Replacement, Main Circuit Board: adım 6, 2 resimden 2.

Use a plastic opening tool to pop the speaker press-fit connector free.
Slide the edge of the tool under the connector and gently lift up on the edge; the connector should pop free with little force.

Düzenle

Adım 7

Use a plastic opening tool to lift the front camera press-fit connector free.

Düzenle

Adım 8

Insert one of the plastic opening tools into any side of the main circuit board and gently pry it loose from the front cover. Repeat the process all around the circuit board.

Düzenle