Ana içeriğe geç

Giriş

If your device is not working due to a faulty power cord, you can follow this guide to easily replace the faulty cord with a new one.

  1. Place the plastic opening tool in the space between the rubber and the plastic case of the device. Apply pressure by pushing upward on the case. Separate the bottom square rubber piece from the case using the plastic opening tool until all clips are detached.
    • Place the plastic opening tool in the space between the rubber and the plastic case of the device.

    • Apply pressure by pushing upward on the case.

    • Separate the bottom square rubber piece from the case using the plastic opening tool until all clips are detached.

  2. Locate the ten J#00 Phillips screws and remove them. Locate the ten J#00 Phillips screws and remove them.
    • Locate the ten J#00 Phillips screws and remove them.

  3. Android Tamir Setleri

    A new screen or battery is one kit away.

    Hemen Alışveriş Yapın

    Android Tamir Setleri

    A new screen or battery is one kit away.

    Hemen Alışveriş Yapın
  4. Place your finger on the short edge of the motherboard and lift it to separate it from the plastic case. Place your finger on the short edge of the motherboard and lift it to separate it from the plastic case. Place your finger on the short edge of the motherboard and lift it to separate it from the plastic case.
    • Place your finger on the short edge of the motherboard and lift it to separate it from the plastic case.

  5. With the mother board back facing you locate the power cord port found on the far left end. With the mother board back facing you locate the power cord port found on the far left end. With the mother board back facing you locate the power cord port found on the far left end.
    • With the mother board back facing you locate the power cord port found on the far left end.

  6. Locate the four soldering joints  for the power cord port found on the top side of the mother board. Desolder the joints of the  power cord port to release it from the motherboard. Place the new power cord port into its original location and solder its joints.
    • Locate the four soldering joints for the power cord port found on the top side of the mother board.

    • Desolder the joints of the power cord port to release it from the motherboard.

    • Place the new power cord port into its original location and solder its joints.

    • Use the iFixit soldering and desoldering guide.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

jeffrey555

Üyelik tarihi: 01-09-2015

319 İtibar

2 adet Kılavuz yazıldı

Takım

USF Tampa, Team 16-3, Wollert Fall 2015 USF Tampa, Team 16-3, Wollert Fall 2015 üyesi

USFT-WOLLERT-F15S16G3

4 Üyeler

14 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 6

Her zaman: 1,377