1. Use screwdriver to pry off the stickers marked in red to reveal the location of the 4 screws.
    • Use screwdriver to pry off the stickers marked in red to reveal the location of the 4 screws.

    Yorum Ekle

  2. Remove the 4 screws to continue.
    • Remove the 4 screws to continue.

    Yorum Ekle

    • Pry the center of the mouse apart to separate the upper and lower housing of the boards.

    Yorum Ekle

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the wires from the white crimp headers. this will separate the upper and lower housing units of the mouse.

    • Pull as far up on the wire as possible, being as careful as possible to avoid ripping the wires.

    Yorum Ekle

    • Take the upper housing of the mouse and begin to remove the two screws (highlighted in red) that hold the board in place.

    Yorum Ekle

    • Gently remove board.

    Yorum Ekle

    • The DPI button is the red push button highlighted in red.

    • To remove it, flip the board over and desolder the wires highlighted in orange.

    • Replace component with new component and resolder back in place.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Colin

Üyelik tarihi: 10-02-2014

349 İtibar

3 adet Kılavuz yazıldı

Takım

Cal Poly, Team 1-39, Maness Winter 2014 Cal Poly, Team 1-39, Maness Winter 2014 üyesi

CPSU-MANESS-W14S1G39

4 Üyeler

8 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 4

Son 30 Gün: 25

Her zaman: 2,061