Use screwdriver to gently pry off the stickers marked in red to reveal the location of the 4 screws
  • Use screwdriver to gently pry off the stickers marked in red to reveal the location of the 4 screws

Yorum Ekle

Remove the 4 screws to continue.
  • Remove the 4 screws to continue.

Yorum Ekle

  • Pry the center of the mouse apart to separate upper and lower housing of the boards.

Yorum Ekle

  • Remove the wires from the white crimp headers. This will separate the upper and lower housing units of the mouse.

  • Pull as far up on the wire as possible, but be careful to avoid ripping the wires.

Yorum Ekle

  • Take the upper housing of the mouse and remove the two screws (highlighted in red) that hold the board in place.

Yorum Ekle

  • Gently remove board.

Yorum Ekle

  • The LED is the red component on this board circled in red.

  • To remove it, flip the board over and desolder the wired highlighted in orange.

  • Replace LED with a new LED and resolder into place.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Colin

Üyelik tarihi: 10-02-2014

349 İtibar

3 adet Kılavuz yazıldı

Takım

Cal Poly, Team 1-39, Maness Winter 2014 Cal Poly, Team 1-39, Maness Winter 2014 üyesi

CPSU-MANESS-W14S1G39

4 Üyeler

8 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 3

Son 30 Gün: 28

Her zaman: 1,371