Ana içeriğe geç

What you need

  1. Anker 2.4G Wireless Mouse LED Replacement, LED: adım 1, 1 resimden 1.
    • Use a spudger to gently pry off the stickers to reveal the location of the four screws.

  2. Anker 2.4G Wireless Mouse LED Replacement: adım 2, 1 resimden 1.
    • Remove the four screws to continue.

  3. Anker 2.4G Wireless Mouse LED Replacement: adım 3, 2 resimden 1. Anker 2.4G Wireless Mouse LED Replacement: adım 3, 2 resimden 2.
    • Pry the center of the mouse apart using a spudger to separate the upper and lower housing of the boards.

  4. Anker 2.4G Wireless Mouse LED Replacement: adım 4, 1 resimden 1.
    • Remove the wires from the white crimp headers. This will separate the upper and lower housing units of the mouse.

    • Pull as far up on the wire as possible, but be careful to avoid ripping the wires.

  5. Anker 2.4G Wireless Mouse LED Replacement: adım 5, 2 resimden 1. Anker 2.4G Wireless Mouse LED Replacement: adım 5, 2 resimden 2.
    • Take the upper housing of the mouse and remove the two screws that hold the board in place.

  6. Anker 2.4G Wireless Mouse LED Replacement: adım 6, 1 resimden 1.
    • Gently remove the circuit board from the mouse.

  7. Anker 2.4G Wireless Mouse LED Replacement: adım 7, 1 resimden 1.
    • To remove the LED, flip the board over and desolder the wires.

    • Replace LED with a new LED and resolder into place.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Colin

Üyelik tarihi: 10-02-2014

406 İtibar

3 adet Kılavuz yazıldı

Team

Cal Poly, Team 1-39, Maness Winter 2014 Cal Poly, Team 1-39, Maness Winter 2014 üyesi

CPSU-MANESS-W14S1G39

4 Üyeler

16 adet Kılavuz yazıldı

0 Comments

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 5

Son 30 gün: 26

Her zaman: 2,675