Giriş

Replace a faulty antenna on the AirPort Extreme Model A1034.

Parçalar

Hiçbir parçaya gerek yok.

  1. Remove the three 14.3mm T7 Torx screws from the bottom of AirPort.
    • Remove the three 14.3mm T7 Torx screws from the bottom of AirPort.

    Yorum Ekle

  2. Remove the 5.1mm Phillips screw from the bottom of the AirPort. This screw is located under the identification sticker. You will have to remove the sticker or make a hole to remove it.
    • Remove the 5.1mm Phillips screw from the bottom of the AirPort. This screw is located under the identification sticker. You will have to remove the sticker or make a hole to remove it.

    Yorum Ekle

    • Lift the bottom and top casing straight apart and then lift metal casing straight up from the bottom plastic casing.

    Yorum Ekle

    • Unplug the black connector on the top of the metal casing by gently pulling horizontally.

    Yorum Ekle

    • Remove the two 4mm phillips screws to remove antenna.

    Yorum Ekle

    • The circuit board connected to the antenna is attached to the metal case with foam adhesive.

    • Gently peel or cut the foam holding the circuit board with a knife and remove it from the AirPort.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Michael Garcia

Üyelik tarihi: 12-10-2011

369 İtibar

5 adet Kılavuz yazıldı

Takım

Cal Poly, Team 17-15, Regan Fall 2011 Cal Poly, Team 17-15, Regan Fall 2011 üyesi

CPSU-REGAN-F11S17G15

3 Üyeler

7 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 13

Her zaman: 4,157