Giriş

In order to obtain access to the internal components you must first follow this step by step general disassembly guide. This will be a first stop in installing a new component that is enclosed by the outer shell.

  1. Turn computer over.
    • Turn computer over.

    • Remove battery expansion cover and battery.

    Yorum Ekle

  2. With monitor hinge at the bottom, remove the two top center screws.
    • With monitor hinge at the bottom, remove the two top center screws.

    Not necessary for RAM, hard drive, or CPU replacement.

    Miles Raymond - Yanıt

    The Screws are T8!

    Willy Kaiser - Yanıt

    • Remove top left and top right screws.

    Also not necessary for RAM, hard drive, or CPU replacement.

    Miles Raymond - Yanıt

    • Remove middle left and middle right screws.

    Yorum Ekle

    • Open computer kickstands.

    • Remove screws underneath each kickstand.

    Again not necessary for RAM, hard drive, or CPU replacement.

    Miles Raymond - Yanıt

    • Lift keyboard from bottom and take out of shell.

    Yorum Ekle

    • Lift the white ribbon clamps securing the keyboard ribbon cables to the motherboard. You can do this using a plastic opening tool.

    • Removing both ribbon cables from the motherboard will leave the clamps like so.

    • From here you can access the logic board, hard drive, and floppy drive.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

7 başka kişi bu kılavuzu tamamladı.

Mark McNeff

Üyelik tarihi: 20-04-2011

469 İtibar

2 adet Kılavuz yazıldı

2 Yorum

http://tim.id.au/laptops/apple/powerbook... (PDF)

Apple Service Source: PowerBook 500 Series

Guides for everything.

tas - Yanıt

Thanks been trying to fix this for a long time

Luke Legg - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 2

Son 7 Gün: 5

Son 30 Gün: 18

Her zaman: 4,295