Eşyalarını Tamir Et Topluluğa Katılın Mağaza

Apple Time Capsule Model A1254 Back Plate Replacement

Giriş

The base plate serves as the under casing for the device. It provide structural security and protection for the internal components. If the base plate is damaged it may put the internal hardware at risk and should be replaced. The rubber covering is held in place by an adhesive and make take some time remove.

What you need

  1. Apple Time Capsule Model A1254 Back Plate Replacement, Back Plate: adım 1, 3 resimden 1. Apple Time Capsule Model A1254 Back Plate Replacement, Back Plate: adım 1, 3 resimden 2. Apple Time Capsule Model A1254 Back Plate Replacement, Back Plate: adım 1, 3 resimden 3.

    • Turn the device upside down to reveal the rubber section of the back plate. Using a metal spudger, carefully wedge the blunt tip into the space between the aluminum back plate and the rubber, separating the two pieces.

    • This may take a few minutes to pry the rubber off completely. Once your are able to get a grip on the rubber it is easier to peel it off using your hands.

    • Depending on air temperature and how set the adhesive is, you may need to spend some time warming the back plate with a hot plate (on low) or hair dryer.

    • Don't worry about re-applying adhesive to the rubber; the remaining adhesive has plenty of strength to affix itself to the aluminum.

    Düzenle

  3. Apple Time Capsule Model A1254 Back Plate Replacement: adım 2, 2 resimden 1. Apple Time Capsule Model A1254 Back Plate Replacement: adım 2, 2 resimden 2.

    • Remove the ten 3mm screws with a Phillips #00 screwdriver.

    • The screws with adhesive covering do not need to be removed.

    Düzenle

  4. Apple Time Capsule Model A1254 Back Plate Replacement: adım 3, 2 resimden 1. Apple Time Capsule Model A1254 Back Plate Replacement: adım 3, 2 resimden 2.

    • The fan affixed to the back plate is connected to the logic board. A small wire must be detached to fully remove the back plate.

    • Pull the base of the wire close to the logic board and the connector will pop off.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

9 farklı kişi bu kılavuzu tamamladı.

Yazar

4 tane daha katılımcı ile

Keaton Frahmann

Üyelik tarihi: 10/06/16

798 İtibar

2 adet Kılavuz yazıldı

Badges: 17

+14 tane daha rozet

Team

Cal Poly, Team 4-2, Livingston Fall 2016 Cal Poly, Team 4-2, Livingston Fall 2016 üyesi

CPSU-LIVINGSTON-F16S4G2

4 Üyeler

15 adet Kılavuz yazıldı

2 Comments

I had to open to destroy the hard drive for security reasons. The rubber bottom was so old it just tore to bits. I used a Dremel Multi-Max with a flat scraper blade to remove it in the end.

steve - Yanıt

must I put back on the rubber bottom or can I leave it off for maximum airflow?

Strider - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 gün: 8

Son 30 gün: 49

Her zaman: 5,718