Eşyalarını Tamir Et Topluluk Mağaza

Asus Vivobook Flip 14 TP410U LCD Assembly Replacement

Giriş

A display can eventually die due to extensive use, or a majority of the times, receive too much damage that it won't function properly. This guide should be followed in order to replace the LCD assembly.

Neye ihtiyacın var

  1. Asus Vivobook Flip 14 TP410U LCD Assembly Replacement, LCD Assembly: adım 1, 1 resimden 1.

    • Turn off the power and disconnected the AC cable from the laptop.

    Düzenle

  2. Asus Vivobook Flip 14 TP410U LCD Assembly Replacement: adım 2, 2 resimden 1. Asus Vivobook Flip 14 TP410U LCD Assembly Replacement: adım 2, 2 resimden 2.

    • Remove the rubber covers for the two screws located at the bottom of the screen.

    • Use a Phillips #00 screwdriver to remove the two 6.4 mm screws outlined in the image.

    Düzenle

  4. Asus Vivobook Flip 14 TP410U LCD Assembly Replacement: adım 3, 2 resimden 1. Asus Vivobook Flip 14 TP410U LCD Assembly Replacement: adım 3, 2 resimden 2.

    • Excessive force may cause damage to connections.

    • Rotate the screen 360 degrees for ease of access.

    • Place the opening tool at the corner of where the screen meets the base of the laptop.

    • Pry open the screen along the edge until it is completely off the front cover.

    • Disconnect each appropriate connector while opening up the laptop.

    Düzenle

  5. Asus Vivobook Flip 14 TP410U LCD Assembly Replacement: adım 4, 2 resimden 1. Asus Vivobook Flip 14 TP410U LCD Assembly Replacement: adım 4, 2 resimden 2.

    • Excessive force should avoided since damage may accrue.

    • Remove the cable that connects to the touch display, front camera, and motherboard.

    • Remove each piece of tape that holds down each cable.

    Düzenle

  6. Asus Vivobook Flip 14 TP410U LCD Assembly Replacement: adım 5, 1 resimden 1.

    • Have the new LCD display fully unboxed and ready to be used.

    • Remove the old LCD display.

    • The touch screen sensor is extremely fragile, make sure to not put excessive force on the cable while assembling.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Yazar

4 tane daha katılımcı ile

Dominic Bento

Üyelik tarihi: 03/22/22

326 İtibar

2 adet Kılavuz yazıldı

Rozetler: 5

+2 tane daha rozet

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 3

Son 7 gün: 10

Son 30 gün: 31

Her zaman: 901