Ana içeriğe geç

BLU Life XL Charging Port Replacement

Neye ihtiyacın var

  1. BLU Life XL Charging Port Replacement, Battery: adım 1, 3 resimden 1. BLU Life XL Charging Port Replacement, Battery: adım 1, 3 resimden 2. BLU Life XL Charging Port Replacement, Battery: adım 1, 3 resimden 3.
    • Turn the device off by holding down the power button for up to 5 seconds and then tapping the "Power off" button on the screen.

    • Remove the rear cover using your hands at the lip on the device back cover. No tools required.

  2. BLU Life XL Charging Port Replacement: adım 2, 3 resimden 1. BLU Life XL Charging Port Replacement: adım 2, 3 resimden 2. BLU Life XL Charging Port Replacement: adım 2, 3 resimden 3.
    • Remove the old battery.

    • For optimal performance, calibrate your newly installed battery: Drain battery below 10%, then charge uninterrupted to 100%.

  3. BLU Life XL Charging Port Replacement, Charging Port: adım 3, 2 resimden 1. BLU Life XL Charging Port Replacement, Charging Port: adım 3, 2 resimden 2.
    • Remove twelve 3mm Phillips #000 screws from the rear plate.

  4. BLU Life XL Charging Port Replacement: adım 4, 2 resimden 1. BLU Life XL Charging Port Replacement: adım 4, 2 resimden 2.
    • Remove the plastic frame on the device using an opening tool.

    • Firmly press the tool into the gap between the front glass and rear plate.

    • The gap is located on all sides of the phone.

    • Run the tool through this gap along the entire edge of the phone to separate the plastic frame from the phone.

  5. BLU Life XL Charging Port Replacement: adım 5, 3 resimden 1. BLU Life XL Charging Port Replacement: adım 5, 3 resimden 2. BLU Life XL Charging Port Replacement: adım 5, 3 resimden 3.
    • Disconnect lower PCB antenna connection.

    • Disconnect lower PCB data cable connection.

    • Remove the single JIS #000 3mm screw from the PCB board.

  6. BLU Life XL Charging Port Replacement: adım 6, 1 resimden 1.
    • Remove the haptic motor at bottom left of the device. This will require a prying tool, as the motor is glued to the device.

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Euan Gordon

Üyelik tarihi: 02/14/18

164 İtibar

1 Kılavuz yazıldı

Ekip

USF Tampa, Team S2-G5, Eyestone Spring 2018 USF Tampa, Team S2-G5, Eyestone Spring 2018 üyesi

USFT-EYESTONE-S18S2G5

3 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 1

Son 30 gün: 8

Her zaman: 1,906