Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

Giriş

Use this guide to remove or replace the handle casing of your Black and Decker LI2000.

  1. Remove the following five screws Three 20 mm Phillips #1 screws One 10 mm #000 Phillips screw
    • Remove the following five screws

    • Three 20 mm Phillips #1 screws

    • One 10 mm #000 Phillips screw

    • One 13 mm Phillips 31 screw

    • When you remove the 13 mm screw, the spring may pop out of the screwdriver. Point the backside of the screwdriver away from your face and others.

  2. Remove the black sticker with recycling information.
    • Remove the black sticker with recycling information.

  3. SKIP THE UPGRADE

    Save by fixing with an all-in-one kit.

    Shop iPhone Fix Kits

    SKIP THE UPGRADE

    Save by fixing with an all-in-one kit.

    Shop iPhone Fix Kits
  4. Use your fingers or a plastic opening tool to pry the casing apart.
    • Use your fingers or a plastic opening tool to pry the casing apart.

  5. Remove the plastic slider by picking it up off the screwdriver.
    • Remove the plastic slider by picking it up off the screwdriver.

    • You may consider leaving half of the casing on the screwdriver to make handling the screwdriver easier.

  6. Remove the four 15mm Phillips #1 screws. Remove the four 15mm Phillips #1 screws.
    • Remove the four 15mm Phillips #1 screws.

  7. Use a plastic opening tool to pry the casing apart. Use a plastic opening tool to pry the casing apart.
    • Use a plastic opening tool to pry the casing apart.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Katherine Simmons

Üyelik tarihi: 08-02-2016

711 İtibar

5 adet Kılavuz yazıldı

Takım

IUPUI, Team 1-3, Baechle Spring 2016 IUPUI, Team 1-3, Baechle Spring 2016 üyesi

IUPUI-BAECHLE-S16S1G3

4 Üyeler

10 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 1

Son 30 gün: 1

Her zaman: 132