Giriş

The pivot button may need to be installed if problems such as jamming of the button occur. This guide will outline how to install the pivot button on the Black and Decker Pivot Plus PD600.

Parçalar

Hiçbir parçaya gerek yok.

Remove the screw located on the opposite side of the black half of the button with the lock symbol with the Phillips #1 screwdriver. Remove the screw located on the opposite side of the black half of the button with the lock symbol with the Phillips #1 screwdriver.
  • Remove the screw located on the opposite side of the black half of the button with the lock symbol with the Phillips #1 screwdriver.

Yorum Ekle

After the screw is removed, take off both sides of the button. You will be left with 3 pieces. Two halves of the button (a black piece with a lock on the front, and a circular orange piece) will be left over along with a spring.
  • After the screw is removed, take off both sides of the button.

  • You will be left with 3 pieces. Two halves of the button (a black piece with a lock on the front, and a circular orange piece) will be left over along with a spring.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Ryan Angelich

Üyelik tarihi: 13-05-2013

101 İtibar

1 Kılavuz yazıldı

Takım

Cal Poly, Team 4-15, Maness Spring 2013 Cal Poly, Team 4-15, Maness Spring 2013 üyesi

CPSU-MANESS-S13S4G15

5 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 1

Her zaman: 711